Product no.: HiT211702
Dr.Pulley high performance clutch HiT 211702 check the size and measurement
In the Dr.Pulley HiT clutch two sets of springs are working: The clutch spring, inside, controls through the centrifugal power the movement of the clutch pads towards the clutch bell (for example at 3000 rpm). The second set of "torque" springs, externally mounted, controls then the pressure by using a "push pin" on the clutch linings (in the example already at 3400 rpm) against the bell, thus preventing most of the slipping phase of the clutch. Because of less friction, much less heat is generated. heat is lost power. The scooter accelerates much faster because the full power transmission to the rear tyre already exists at 3,400 rpm, instead of 4000rpm with a normal clutch.
The HiT clutch is very effective while driving with frequent speed changings: To accelerate out of curves or at mountain trips. Or for a powerful overtaking. The graphs show a marked increase in speed and performance especially in low and medium speed ranges.
With the two fully enclosed sets of spring , the clutch can be customized to all personal needs. For example, if you want to get more power at start, choose a stronger clutch spring to increase the starting rpm. If you want to shorten the slipping phase of the clutch, you should select a weaker pillow (torque) spring. Extreme: To get an extreme start (wheely), choose a strong clutch spring, and a very weak (or no) pillow (torque) spring.
For those who do not want to experiment long, an average spring combination is already installed with delivery.
Importatant: Together with the HiT high performance clutch the use of not too light vario weights is strongly recommended. The best result you get with Dr.Pulley slider rolls with the same
HiT high-performance clutch, depending on the model with 3 or 4 clutch pads
Minimum of 3 complete sets of clutch springs and torque (pillow) springs
"Washer" rings to increase the pressure of the counter-pressure spring
Spare pins and springs, sticker, instructions, link to the HiT manual
Fits the following Scooters / Scooter / ATV (see also Dr.Pulley Forum)
Vespa: LX125, S125
19 % VAT incl. excl. Shipping costs